← All articles

How to winterize a lawn mower before storing it

The single biggest reason mowers won't start after sitting idle for several weeks is old ethanol gas sitting in the carburetor all winter. The ethanol pulls moisture out of the air, the fuel separates, and what's left behind in the carb jets is a gummy varnish that blocks fuel from getting through.

Here's what I try to do every fall to make sure my mower starts right up in the spring:

Use the right fuel

  • Non-ethanol gas. It's not cheap but I'd rather pay a few extra dollars than standing there yanking on the starter cable over and over. You can find pre-mixed non-ethanol gas on Amazon and have it shipped to you.
  • Stabilizer and a full tank. Add fuel stabilizer to your gas, which basically removes the ethanol. This approach is ideal if you've already filled the tank with regular unleaded gas.

Change the oil while the engine is warm

Warm oil is thinner and runnier, which means it will drain more thoroughly. Run the mower for a few minutes first so the oil is warm and thin, then drain it. Refill with whatever weight the manual calls for — usually SAE 30 for a small air-cooled engine, or 10W-30 if you're in a climate where it'll get cold-started in early spring.

Check the spark plug

Take the spark plug out and look at the tip, which should be a light tan color. Black and sooty means it's been running rich, white means lean, oily means you've got a bigger problem. If yours has been in there a couple of seasons, it's probably wise to just replace it and they are only a few dollars.

Before you put the new plug in, squirt a small amount of oil into the cylinder through the plug hole and pull the starter cord a few times to coat the cylinder walls. Then install the plug. That thin film of oil keeps the cylinder from rusting over the winter.

Clean the deck underside

Tip the mower on its side (carburetor and air filter facing up, not down, or you'll flood the carb with oil) and scrape the caked grass off the underside of the deck with a putty knife or a hose jet. Wet grass clippings hold moisture against the steel all winter and that's how decks rust through from the inside. Once it's scraped, hit it with a wire brush on anything that's starting to flake, and spray it down with a light coat of oil or deck spray.

Sharpen the blade and check the air filter

With the mower already tipped over, pull the blade off. Either sharpen it on a bench grinder or a file, or swap in a new one.

Check the air filter. Paper filters get replaced when they're dirty, foam filters get washed in soapy water, dried, and lightly oiled.

Riding mowers: the battery

If you've got a riding mower, the battery is likely to die over the winter if you leave it connected. Either disconnect the negative cable and pull the battery into the garage or basement, or leave it in and hook up a trickle charger (a Battery Tender or similar) that keeps it topped off.

Where to store it

A shed or garage both work. If you can get it off a concrete floor and onto a piece of plywood or a pallet, do it, because concrete wicks moisture up into the underside of the deck and the wheels. Don't store it outside under a tarp. The tarp traps moisture against the mower and you end up with more rust than if you'd just left it in the open.

Follow these tips and next spring your mower will thank you by firing right up after the 2nd or 3rd cable pull.

Leave a comment

Comments are moderated — I read every one. Your email is only used if I need to follow up; it isn't published. Links aren't allowed.

← All articles